Skip to main content
Ironclad Commercial Floors logo
Baseboard & Moisture Barriers in Vancouver, BC by Ironclad Commercial Floors

Resilient & Vinyl

Baseboard & Moisture Barriers in Vancouver, BC

Ironclad Commercial Floors provides Baseboard & Moisture Barriers in Vancouver, BC and across Metro Vancouver. Rubber and vinyl wall base plus slab moisture mitigation systems that protect walls and keep new floors bonded.

Overview

Finished edges and dry slabs — the details that protect your floor

Two of the most overlooked parts of a flooring project are the edges and what's coming up through the slab. We install rubber, vinyl and profile wall base with tight corners, and apply moisture mitigation and vapour-control systems when RH testing shows the slab is too wet for adhesives.

Prevents failures

Moisture barriers stop adhesive breakdown, bubbling and mould.

Protects walls

Base absorbs bumps from carts, chairs and cleaning equipment.

Sharp finish

Hand-formed corners and continuous runs with minimal seams.

Warranty protection

Testing and mitigation keep manufacturer warranties valid.

Baseboard & Moisture Barriers in Vancouver, BC

Baseboard and moisture barrier work in Vancouver protects new floors from the damp slabs common in our coastal climate. We test slab moisture with RH probes, apply epoxy or urethane moisture mitigation where readings demand it and finish with rubber, vinyl or tile base. Skipping this step is the most frequent reason floors lift or bubble in Vancouver buildings.

For baseboard & moisture barriers as part of a bigger project, see our commercial flooring installation in Vancouver or our commercial flooring repair in Vancouver.

Our Process

Baseboard & Moisture Barriers: our process

  1. 01

    RH probe testing

    In-slab relative humidity probes measure vapour emission so your moisture barrier decision in Vancouver is based on data.

  2. 02

    Profile the slab

    The concrete is shot-blasted or ground to create the profile a moisture mitigation coating needs to adhere.

  3. 03

    Apply the barrier

    A two-coat epoxy or urethane moisture barrier is applied at the rate required to bring emissions within limits.

  4. 04

    Fit the baseboard

    Rubber, vinyl or tile base is installed against the finished floor, closing the edge and protecting walls.

FAQ

Baseboard & Moisture Barriers in Vancouver FAQs

We drill and set RH probes per ASTM F2170. If readings exceed the flooring manufacturer's limit, a barrier is recommended. Results are included in your free estimate, before any LVT or sheet vinyl goes down.

Service Areas

Baseboard & Moisture Barriers across Metro Vancouver

Free on-site estimate

Need baseboard & moisture barriers in Vancouver?

Tell us about your baseboard & moisture barriers project in Vancouver, BC — we will measure, test the substrate and send a clear, itemized quote.

Read our reviews on